If there is an issue with the SMC PFM006 hardware emulator, there may be a problem with it, according to the manufacturer, there may be a problem with the power management software PPN001. Ialso repositioned the touchpad so it's flush with the top of the touchpad cutout this way, no water drops will have a difficult time getting into that area. Failed Battery/Charger Error? Any water drops would have a difficult time getting into that area once more. In AD, the PFM006 and PPN001 are no longer available, but ASD EFI has given me a new surprise: the ERROR Sensor is reading above the maximum test limit. If you want to remove the LCD panel and add a bit of foam between the ALS and backlight sheets, or replace the entire assembly, there is no way to fix this unless you want to cut the LCD panel and stick a bit of foam between the ALS and backlight sheets. For liquid leakage or burned pins, check the trackpad cable pins and trackpad board for liquid leakage or burnt pins. Take the logic board and check the bottom for liquid leakage, particularly around the SMC and top right, where the CPU thermal sensors are located. Iplan to open the computer and wipe the fan with compressed air, as well as clean the trackpad cable, thermometers, and the iSight cable, along with the Iplan to open the computer and clean the fan with compressed air.
However, ASD OS's interactive ALS test passes. Since the screen and keyboard brightness does not change when blocking the ALS, the ALS appears to not work. To lower the fan speed, the previous owner used Macs Fan Control to lower the fan speed. This MacBook Pro's fan is running at full throttle, and the kernel_task is at +300% with +100 threads.
0 kommentar(er)
